|
resetting TF3000CIpro
Try This to rectify your problem
TOPFIELD TF3000CIpro : Resetting to factory defaults (Deletes existing settings)
*This step in not required unless you have made an error and wish to start from the Top
- Power the unit on, press menu key on the remote, select installation, press OK
scroll down to Factory settings using the P- button, press OK, Using the V- button
select yes and press OK, using the V- button select yes again and press OK.
Press OK again to continue and you should now be in the installation menu ready to
do a first time installation.
TOPFIELD TF3000CIpro : First time Installation
1- Power the unit on by pressing the standby button on the remote control
(Please make sure the batteries have been installed into the remote unit)
2- Main menu should appear on the screen
3- Press the P- button and select Installation press OK
4- Installation menu should appear, LNB Settings should be highlighted in yellow
press OK. You should now be in LNB Setting screen, Press OK and scroll down
using P- key untill OptusB3 is highlighted in white. Press OK. Press P- scroll
down to LNB Frequency and press V+ twice untill you see 5150. Using the remote
keypad numbers punch in the numbers 11300 . In the bottom right hand side
you should see two bar levels (level & quality) both nearly at the 90% mark.
Scroll down using the P- key untill channel search is highlighted yellow, press OK.
Now you should be in the Channel Search menu. Scroll down using the P- key to
untill you see the Start Search highlighted in yellow and press OK.
* On Older models (Units purchased before 01-04-2003 use the instructions in 4A)
5- You should now be in the Searching screen and the unit should start searching for
stations by scrolling them down in increments.It will take approx. 90 seconds to
pre-tune to all stations relevant to that satellite and at the end should say -
search complete 183 TV, 111 Radio searched Press OK to continue (TV and radio station
numbers depends on the providers transmission at the time of broadcast) Press OK.
6- Press exit. (If the satellite dish & lnb and cable installation was done properly
you should be now ready to view the desired channels)
***END***
*4A- Use this in place of step 4 if the Unit was purchased before 01-04-2003
Installation menu should appear, LNB Settings should be highlighted in yellow
press OK. You should now be in LNB Setting screen, Press OK and scroll down
using P- key untill OptusB3 is highlighted in white. Press OK. Press P- scroll
down to LNB Frequency and press V+ twice untill you see 5150. Using the remote
keypad numbers punch in the numbers 11300 . In the bottom right hand side
you should see two bar levels (level & quality) both nearly at the 90% mark.
Scroll down using the P- key untill channel search is highlighted yellow, press OK.
Now you should be in the Channel Search menu the satellite name should appear
highlighted, press OK, on the right hand side a list of satellite names should appear
with the OptusB3 highlighted in white. Press OK. Scroll down using the P- key to
untill you see the Start Search highlighted in yellow and press OK.
regards
Dave
Double D Technology
|
Linear Mode
