Serious BUG in Flubber

[papoulis]

I have Flubber sequel on 7020 installed on CF and on USB disk...i also have internal HD 80 MB
The only place i havent tried to install it is in internal flash
Problem is that it installs fine and runs off CF and USB disk
For the first time all its perfect
After 1st reboot if you go into Blue button -> Softcam setup
it stays there forever in a black screen
The box is ping-able you can telnet ftp etc but enigma is not working
I see only a black screen
If i reboot it loads until i get into that menu

ONLY the first time after installation i can get into that menu and install softcams , cardservers etc

After 1st reboot i cannot enter it nomore (and the chosen softcam doesnt decode)

Im curious how nobody hasnt notice that all this tme

[PubGate]

Hi mate;

My guess is that it is related to your special configuration: USB, CF and HD simultaneous. Try reinstalling the image on HD with CF and USB removed and experiment again the blue panel. If it works than the reason maybe because of some bug, Enigma is linking the /var folder to the wrong device.

CU around
PubGate

[papoulis]

i had tried what you say (CF only and no USB disk)
i had also try removing the CF and booting from USB disk
it boots but again the same thing happens you can try and see for yourself
im sure its a bug

[robb]

Did you do a "reset to factory defaults" after install?

[papoulis]

i did as you said...uninstalled and re-installed the image on USB drive
...booted...did reset to factory defaults...
started configuration...when i chose 2 LNBs with Diseq (what i have)
it stuck there on the blue screen and never went any further...

when i was installing the image with Flashwizzard, it was copying the settings
from Gemini that's why it was booting (until it stucks after reboot on blue button menu -> Softcam config)

So where is the problem ?
Why cannot i install Flubber Sequel on 7020 ?


P.S. I try to fool it and get past that...i chose "No Diseq"...it reported "Loading Networks Failed"....and shut down by itself

[papoulis]

i see you run out of inspiration
i wonder what kind of "image" is this and how you manage to load it

[papoulis]

i 'discovered' that removing completely CF and puting the Gemini image to internal flash (NOT with flashwizzard and NO boot menu) the problem is 'solved'
but thats no solution
i think that it IS possible to have HD, usb HD and CF at the same time mounted on 7020 , am i wrong ?

Still havent managed to run Pli