"Service could not be found" problem

[kflash]

I have a "new Dreamer problem"

I have 4 LNB configuration (Astra, HotBird, Sirius, Hispasat) and running latest ruDream image on my Dreambox.

When I'm zapping thought channels on different satellites I get "Service could not be found" message when switch from one satellite to other. If then I switch through few programs on same satellite I get picture and it works fine until I try to watch some other channel on different satellite.

It is little bit annoying, I would appreciate if someone could give me some advice how to fix it.

[u9689]

this happen to me before the reason was the LNB wireing was not go fit .

if your wiring ok turn off/on

[kflash]

Is it possible that I configured something wrong in my Satellite configuration (4 Satellite via DiSEqC OPT A/B)

I can change position of satellites, but it still somehow works (program searching works). I am not 100% sure which LNB is connected to witch DiSEqC port.

Or I can do something with "non standard user defined configuration..."

Or should I call "my favorite dish installer"

Pls, help

[jura]

Chack on diseq who is who (A,B,C,D) or 1,2,3,4.
Change:
1-st LNB A/A
2-nd LNB A/B
3-rd LNB B/A
4-th LNB B/B
and scan not multi satelite, do it automaticly but single,first satra, next step after ended Eutelsat etc.
Rgds

[Tom0000]

I am using diseqc 1.1 version of setting in dreambox. It lets to define number of repeat of diseqc commands. I need it , because I am using switches in cascade.

kflash
I hope, sending diseq commnad second time should help in your problem

[kflash]

Thx guys!

I'll try to figure out which port on diseq is withc LNB. I am little bit suprised that all works even if I mix satellite in configuration.

Tom, what do you mean by "diseqc 1.1 configuration"?
Where it can be found - in "non-standard user..."?

I can't find any definition of diseqc commands.

Any hints?