"Some" problems with EDG-Nemesis 3.2 on TGS 100

[joggibear]

Hello,

I have a TGS 100 and flashed it with the EDG-Nemesis version 3.2. The TGS 100 was brand new.
Everything went well, I did the factory reset and rebooted.
During the bootup I can see the Nemesis screen and after that use the receiver just as before.

Now my question: according to what I read, when I push the blue button on the remote control, I should get into the Nemesis Panel.
Instead I get the usual plugin window.

Have I done something wrong ? I have been reading online now for quite a time but can't find an answer. The website of the Nemesis team is mostly in Italian. I have asked there already but I am getting quite frustrated trying to read Italian and up to now nobody has answered yet. Is there some kind of "manual" online for the firmware ? What are the real benefits ?

What other images would work on the TGS 100 ?

Regards

JoggiBear

[LAVA36]

Hi lava36,
is necessary a "FACTORY RESET" ! :
-Turn on the power button and press a "UP BUTTON" (bios mode...)
-Select "FACTORY RESET"
-Press a "RIGHT BUTTON" for confirm

[LAVA36]

Hi
is necessary a "FACTORY RESET" ! :
-Turn on the power button and press a "UP BUTTON" (bios mode...)
-Select "FACTORY RESET"
-Press a "RIGHT BUTTON" for confirm

[ringo11]

Originally Posted by joggibear

Hello,

I have a TGS 100 and flashed it with the EDG-Nemesis version 3.2. The TGS 100 was brand new.
Everything went well, I did the factory reset and rebooted.
During the bootup I can see the Nemesis screen and after that use the receiver just as before.

Now my question: according to what I read, when I push the blue button on the remote control, I should get into the Nemesis Panel.
Instead I get the usual plugin window.

Have I done something wrong ? I have been reading online now for quite a time but can't find an answer. The website of the Nemesis team is mostly in Italian. I have asked there already but I am getting quite frustrated trying to read Italian and up to now nobody has answered yet. Is there some kind of "manual" online for the firmware ? What are the real benefits ?

What other images would work on the TGS 100 ?

Regards

JoggiBear

In your post you ask what images goes with Itg TGS 100.
I would strongely recommend DS Team 3.6 No problems with that image.
You can get it here: DS Team Board (Powered by Invision Power Board)
Also use DS-CVS 20.03.2008
Just follow the intructions and your Itgate will work great.
I have tested a lot of images for my TGS 100 and have found out that this DS image is the best.