Humax IR-ACE Factory Default

hiritek · #1 (**permalink**) 10-03-2003

Hi People,

I have set my Humax IR-ACE to factory default by mistake.. (pushing too many buttons too fast).
Now when i turn the device on, it comes straight up with an error message that says "No Services were Registered".
Im still in the process of aligning the satellite to hit the Optus C1, and failing misserably.

What settings do I need to input back in the HUMAX so that I can get some sort of signal out of the C1 Dish?

Also, once I have pinpointed the C1, how do i save these settings back into the HUMAX?

These are the settings that I currently have on the box:

*Antenna Settings:*
Antenna Alt = 1
Sat Name = Optus C1
LNB Freq = 11300
22KHz Tone = Disabled
DisEqC Input = Disabled
Motrised Sys = Disabled
LNB Power = On
LNB Voltage = Standar

*Manual Search:*
Freq = 12559
Polarisation = Vertical
Symbol Rate = 30,000
FEC = 3/4
Newtwork Search = Yes
Auto Skip = No
BAT Search = No

Are these settings AOK for me to get the Optus C1 sat? or should i change any of these? Once again, when I actually get the sat, how do i save these settings? I Cant seem to find this option..

Thanks heaps!

tiapan · #2 (**permalink**) 10-04-2003

Having similar problems after setting up friends Humax IR-ACE .
Worked fine yesterday when I set it up. He switched it off over night and now gives same error message and settings all lost as mentioned previous post.

My humax 5410Z works find.

Is new Humax IR-ACE a dud?

Tazsat · #3 (**permalink**) 10-25-2003

I realise this is abit of track,,,,, But I setup a IR-Ace-M and now when a channel cuts to a commercial... the picture and sound distort as if it is going into overload,,,, The signal Quality I have is 100% with signal strength at 97% ,,,,,,,, could it be that I am feeding to much signal into the unit and it is in fact overloading the front end.... I have never known of this before... quite the opposite,, but with C1 up and thundering out such a big signal,,, could this possibly be the cause..... anyone else had same prob or can shed some light.... should I detune the signal quality,....??

r/ Taz

laika · #4 (**permalink**) 12-07-2003

I did exactly the same thing. After cursing for a day I manually entered the frequency ffc setting etc, crossed my fingers and hit the search button. Received all lost channels.