UEC Decoder 660 DiSEqc Settings

[mindsweeper4u]

Hello Everyone,
This is the first time i am posting on this forum. I have a problem with my uec 660. I am using it in a building where they have a Televes Multimat switch which takes input from the Dish (LNB's) and many receivers are connected using this switch.
Now my problem is when i connect my decoder it cannot tune to any transport streams. There are certain LNB settings which need to be changed so that i can communicate with the LNB and in the LNB Setup Menu i have the following settings:
-LNB Power is : on
-LNB Mode : Dual Frequency
-LNB Lo Frequency: 9750
-LNB Hi Frequency: 10600
-DiSEqC CMD: E01038C0
-Tone Burst: None

I need to know what should the settings be if it is being used with a switch. I have tried a lot of settings but of no use. It will be great if you guys can help me out here. Thanks.

[mindsweeper4u]

Hello All, I think my question was too complicated. Let me make it a bit more clear.

Anyways now i know a little bit more about the settings. There are two main LNB's attached. One is on Port A and the Other one is on Port B.

All i want to know now is that what is DiSEqc CMD I need to input in the LNB Settings of my Receiver to select Port B. As i have tried the original settings for Port A and it is showing the channels for Hotbird. But LNB on Port B is not taking it by default.

It will be really great if you guys can help me out.

Thanks.