AT90S85815A 24C256 funcard Hex ??

[Rentakill]

Hi Guys.

Anyone have the appropriate Hex files kicking around for programming up a AT90S85815A 24C256 funcard.
Looking at using for Aurora irdeto1.

Have tried a few Hex files found via the search button, but havent relly had to much luck.
Are using Cas3 programmer.

Have previously programmed up Golds/Silvers etc, so have a valid set of Card details.

Can anyone point me in the right direction..

Also, I see some posters have mentioned that they dont use the external Eeprom for storage or Card details, instead opt to use the internal Eeprom.

Is this correct, or have i read wrong ?.

Cheers:

[doorman007]

Dito for me
I have done a goldie (aurora) now I want to do a fun4 with the same details,
any help would be great
cheers

[billy t]

Originally Posted by Rentakill

Hi Guys.

Anyone have the appropriate Hex files kicking around for programming up a AT90S85815A 24C256 funcard.
Looking at using for Aurora irdeto1.

Have tried a few Hex files found via the search button, but havent relly had to much luck.
Are using Cas3 programmer.

Have previously programmed up Golds/Silvers etc, so have a valid set of Card details.

Can anyone point me in the right direction..

Also, I see some posters have mentioned that they dont use the external Eeprom for storage or Card details, instead opt to use the internal Eeprom.

Is this correct, or have i read wrong ?.

Cheers:

i dont know if this site is any good but you might be able to find something
Duwgati Satinfo - www.duwgati.com

[Rentakill]

Hi Billy T.

Thanks for the link..
Allready scanned out that Site.. Its a bloody good site with plenty of informations.
Not really any signs of Card Files though, as expected though.

I'll keep surfing round.. They'll pop up somewhere..


Cheers:

[doorman007]

Here we go
I used cardmaster 2.3 for the crd's
remember to use chipcat to programme (int eprom loads automatically)
Works mint
Now I can sleep :-)

[Rentakill]

Hi there

Ive obtained an active AT90S85815A 24C256 which is working,
using the Cas3 interface and Smartcard programming application via Duolabs software, i perform a read of the original working card.
After reading the Flash.hex, and Eeprom Int Data, i then save and reload these files to my Blank.
Then receiving confirmation that the Cas3 and succesfully completed the write process i find the New card is not valid, and does not load up via LMedit to view its details.

I'm picking that the original Funcard is protected ?.
Anyone have any ideas or pointers to help me copy this card.

Other Alternative :

I have made numerous attempts at creating my own Funcards using various files etc as like in a previous posting above.
Where i fall down is the process by where i have to edit my card details into the file.
Whats the best method to do this,

My usual prceedure as used with Silvers and Golds doesn quite work.
I was hoping that like the silvers i would just write to PIC/Atmel, Then Author up Eeprom with Lmedit and then enter in details..

Cheers