DreamBoxEDIT and SETTINGS on USB stick

[excuseme]

Ciao, as promises:

________________________________
| |
| SETTINGS ON STICK USB |
|_______________________________|


-> set LAN on images installed on stick-USB,
AS WELL AS set on base-image of receiver.

-> boot receiver and CHOOSE IMAGE WE WANT SEND SETTINGS

and so on, LEAVING RECEIVER ON
__________________________________________________ ____
GOING TO LOAD SETTINGS (through FTP) with DreamBoxEDIT
__________________________________________________ ____

-> on IMAGE version from 107:
set options in DreamBoxEDIT,
to do
SATELLITE.XML
will be sent to
/var/etc/
(DON'T WRITE COMPLETE PATH OF IMAGE)

Proceed with DreamBoxEDIT,
-> (through FTP) SEND FILES TO DREAMBOX,
you must have a confirmation message
about well done
-> after sending RELOAD command,
WAIT AT LEAST FIVE MINUTES,
files will be loaded and registered
-> EXIT from DreamBoxEDIT
WITHOUT REBOOTING FROM THIS!!!!!!!

-> on confirmation that all well done:
AT LEAST FIVE MINUTES AFTER RELOAD COMMAND,
by pushing on (TV) of your remote control,
you can appreciate changes.

================================================== ======

In order to explain more about complete path of image,
note that directories we are speaking about,
are SUBdirectories of which contain usb-image:
/var/mnt/usb/image/1,2,3,4,5,6,7,8,9/........

================================================== ======

IMAGE version up to 106
-----------------------

All settings file,
EXCEPT SATELLITE.XML,
are stored on:

/var/tuxbox/config/enigma/

SATELLITE.XML
is stored on:

/var/tuxbox/config/

================================================== ======

IMAGE version from 107
----------------------

All settings file,
EXCEPT SATELLITE.XML,
are stored on:

/var/tuxbox/config/enigma/

SATELLITE.XML
is stored on:

/var/etc/

================================================== ======

DiSEqC Rotors:
--------------

DreamBoxEDIT does not in any way use DiSEqC settings
(DiSEqC is used for rotating dishes).
DiSEqC settings are not stored in the same settings files,
as the services,
but in a file called 'registry' on the Dreambox,
where various Dreambox settings (like network, skins etc) are kept.
Editing of those settings is done through the Dreambox setup function.

The relation between services settings and DiSEqC:

The setting files describe a service,
on which satellite the service can be found
and what the position of that satellite is (degrees East or West).
From there on,
the Dreambox will use the DiSEqC settings in the 'registry' file
to send commands to the dish rotor
to let the dish turn to the right satellite position.

Thus, there is no 'direct' relation
between the settings files you can edit with DreamBoxEDIT
and the DiSEqC setup.
--------------------------------------------------------
It's all the same about DiSEq-switch between more dishes.
--------------------------------------------------------

Ciao,
Excuseme.