Still not working...
Toggled Power-On Tests, but still no answer
when trying to connect through DreamUp
Tried enabling boot device to serial(S1)
now I can't even connect to the box via hyperterminal...
Last msg tru hyperterminal:
""------------------------
Installed RAM: 48 MB
Checking RAM between 0x00000000 and 0x01FFFFFF
Checking RAM between 0xA0000000 and 0xA0FFFFFF
System RAM check complete
Booting from [S1] Serial Port 1...
PLEASE NOTE: You must now...
a. Exit from terminal emulation mode
b. Modify the baud rate of your host session to 115200
c. Transmit a file to the target using kermit
d. Reset the host baud rate to 9600
e. Reenter terminal emulation mode
f. Hit enter to continue
---------------------------""
What is the file ? And more importantly what will it do?
Can I get back to normal hyperterminal msg?
I'm going nuts!!! Help!!!
Athoz