[athoz]

I am having a boot problem with my 5620
I've read the thread about boot problem in this forum arquive,
but had no luck, it didin't solve my db problem.

What I did;

1) Ran dreamUP to upgrade to official image 1.06.

2) Ran dreamUP again. Selected Erase button (wished I didn't!!) it started fine but at the end (whole blue bar filled) got an error saying flash could not be erased (-4).

3) Pressed flash button, didn't work. No upload possible, didn't get window to select image.

4) Unplugged the db, waited 1 minute. Reboot trying to connect to Dreamup, but dreamup isn't able to connect to db ( get 5600 boot on db and no image on TV).

5) Tried reset and then hold the up arrow key on the DBox until I see 999 message, but got no 999 message...

6) Followed the advice on the forum and waited 24 hours (db unplugged), but still unable to connect dreamup to db.

7) Tried using hyperterminal, I get the menus normally:

--- Device Configuration ---
Power-On Test Devices:
000 Disabled System Memory [RAM]
002 Disabled Ethernet [ENET]
----------------------------
Boot Sources:
001 Enabled Application in Flash [FLASH]
002 Disabled Ethernet [ENET]
local=0.0.0.0 remote=255.255.255.255 hwaddr=0009341e9d0c
003 Disabled Serial Port 1 [S1]
Baud = 9600
----------------------------
Automatic Boot: Enabled
----------------------------
1 - Toggle Power-On Tests
2 - Change a Boot Device
3 - Change IP Addresses
4 - Ping test
5 - Change Baud Rate for S1 Boot
7 - Toggle Automatic Boot
D - Display Configuration
S - Save Changes
0 - Exit Menu and Boot Application
->

8) I can use all the options and they respond ok.

My question is what can I do to re-alive my 5620, i.e. is there anything I can do before goig to extreme measures as using jtag?
Thanks
Athoz